When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.ġ3) Unplug this apparatus during lightning storms or when unused for long periods of time.ġ4) Refer all servicing to qualified service personnel. Manufacturer, or sold with the apparatus. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.ġ0) Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.ġ1) Only use attachments/accessories specified by the manufacturer.ġ2) Use only with the cart, stand, tripod, bracket, or the table specified by the The wide blade or the third prong are provided for your safety. A grounding type plug has two blades and a third grounding prong. A polarized plug has two blades with one wider than the other.
Install in accordance with the manufacturer’s instructions.Ĩ) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.ĩ) Do not defeat the safety purpose of the polarized or grounding-type plug. DO NOT ALLOW CHILDREN TO HANDLE THE SD CARD.ħ) Do not block any ventilation openings. ≥Since this product gets hot during use, operate it in a well ventilated place do not install this equipment in a confined space such as a bookcase or similar unit.ĪS WITH ANY SMALL OBJECT, SD CARDS CAN BE SWALLOWED BY YOUNG CHILDREN. REPLACE ONLY WITH THE SAME OR EQUIVALENT TYPE. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.ĬAUTION: TO PREVENT FIRE OR SHOCK HAZARD AND ANNOYING INTERFERENCE, USE THE RECOMMENDED ACCESSORIES ONLY.ĬAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.ĬAUTION: DANGER OF EXPLOSION IF BATTERY IS INCORRECTLY REPLACED. This device complies with Part 15 of the FCC Rules.
Responsible party: Matsushita Electric Corporation of America One Panasonic Way, Secaucus, NJ 07094 Support Contact: Panasonic Consumer Electronics Company Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. ≥Consult the dealer or an experienced radio/TV technician for help.įCC Caution: To assure continued compliance, follow the attached installation instructions and use only shielded interface cables with ferrite core when connecting to computer or peripheral devices. ≥Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
≥Increase the separation between the equipment and receiver. ≥Reorient or relocate the receiving antenna. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: However, there is no guarantee that interference will not occur in a particular installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
FCC Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.